Convert CISCO Aironet AP from controller to autonomous version

Z DCEwiki
Skočit na navigaci Skočit na vyhledávání

Konverze z Light na Autonomous verzi

Zde je postup konverze AP - http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html#wp160918 Kromě přímo připojeného TFTP serveru s IP 10.0.0.2 potřebujete akorát image IOSu, který vytáhnete buď z jiného AP nebo bych Vám ho někde zpřístupnil. Soubor je pak třeba přejmenovat na c1140-k9w7-tar.default

Using a TFTP Server to Return to a Previous Release

Note This section does not apply to Cisco C3201WMIC and Cisco C3201LAP.

Follow these steps to revert from LWAPP mode to autonomous mode by loading a Cisco IOS release using a TFTP server:

Upozornění A tftp-hpa implementation of the tftp server as in net-ftp/tftp-hpa package is not compatible with Aironet bootloader code. Uploading of IOS image fails with: ERROR: Image is not a valid IOS image archive.
  1. The static IP address of the PC on which your TFTP server software runs should be between 10.0.0.2 and 10.0.0.30.
  2. Make sure that the PC contains the access point image file (such as c1200-k9w7-tar.122-15.JA.tar for a 1200 series access point) in the TFTP server folder and that the TFTP server is activated.
  3. Set the timeout value on the TFTP server to 30 seconds.
  4. On the PC where the TFTP server is located, perform these steps:
  5. Disable any software firewall products, such as Windows firewall, ZoneAlarm firewall, McAffee firewall, or others.
  6. Ensure all Windows files are visible. From Windows Explorer, click Tools > Folder Options > View; then uncheck the Hide extensions for known file types check box.
  7. Rename the access point image file in the TFTP server folder to c1200-k9w7-tar.default for a 1200 series access point, c1130-k9w7-tar.default for an 1130 series access point, c1240-k9w7-tar.default for a 1240 series access point, and c1250-k9w7-tar.default for a 1250 series access point.
  8. Connect the PC to the access point using a Category 5 (CAT5) Ethernet cable.
  9. Disconnect power from the access point.
  10. Press and hold MODE while you reconnect power to the access point.
  11. Hold the MODE button until the status LED turns red (approximately 20 to 30 seconds) and then release.
  12. Wait until the access point reboots, as indicated by all LEDs turning green followed by the Status LED blinking green.
  13. After the access point reboots, reconfigure it using the GUI or the CLI.
Citováno z „https://wiki.control.fel.cvut.cz/mediawiki/index.php?title=Convert_CISCO_Aironet_AP_from_controller_to_autonomous_version&oldid=18229“